background image

TP-08122

(16579/22882)

Issued 09-09

Printed in USA

Copyright ArvinMeritor, Inc., 2009

Page 3

CWS: Collision Warning

If the lead vehicle is braking or traveling more slowly than the 
driver’s vehicle, CWS warns of an impending collision by emitting an 
urgent audible alert and displaying the collision warning symbol.

The braking control is NOT active. The driver must initiate braking. 
The display background is red. Figure 5.

Figure 5

Adaptive Cruise Control

Adaptive Cruise Control (ACC) is a radar-based system that works in 
conjunction with conventional cruise control to maintain the set 
cruise speed when no vehicle is being tracked and maintains a 
minimum following interval when a target vehicle is being tracked. 
The minimum following interval is maintained by automatically 
decelerating the vehicle using throttle, engine and foundation 
brakes without driver intervention. When the target vehicle is no 
longer being tracked, the set cruise speed resumes automatically.

ACC: Standby

When cruise control is engaged and no lead vehicle is detected, 
OnGuard™ operates similarly to conventional cruise control. The 
cruise control set speed is shown. The display background is blue. 
Figure 6.

Figure 6

ACC: Object Detected

When a lead vehicle is detected in the lane ahead, the display 
shows that ACC is on and and the radar is tracking a target at the 
speed shown. The display background is green. Figure 7.

Figure 7

ACC: Following-Interval Alert

If the driver is using the accelerator pedal to override the cruise 
control and approaches a vehicle too closely, the following-interval 
alert will emit a moderate audible signal. This signal will end when 
the driver’s vehicle speed drops below the lead vehicle speed and 
the following interval is increased. The following-interval alert is 
disabled (will NOT alert) when the driver’s vehicle speed is below 15 
mph. The display background is yellow. Figure 8.

Figure 8

ACC: Collision Warning

If the lead vehicle is braking or traveling more slowly than the 
driver’s vehicle, ACC warns of an impending collision by emitting an 
urgent audible alert and displaying the collision warning symbol.

The braking control will activate and slow the vehicle. The driver 
must also initiate braking. The display background is red. Figure 9.

Figure 5

Figure 6

400734

9a

15 FT

CWS

15 MPH

4007145

a

Set:

  60 MPH

Figure 7

Figure 8

400714

6a

Set:

  60 MPH

230FT

55 MPH

400714

6b

Set:

  60 MPH

100FT

55 MPH

Содержание OnGuard Display













Отзывы: