COPYRIGHT
1996 MERIT INDUSTRIES, INC.
PM0070-0C
MEGATOUCH SUPER IV MANUAL
3
Maintenance
Cleaning the Cabinet
•
The cabinet should be cleaned with a damp cloth
and mild detergent.
Cleaning the Touchscreen Monitor
•
The touchscreen monitor should be cleaned with a
damp cloth and mild detergent.
To gain access to the entire surface of the monitor
screen on the upright model, you will have to release the
monitor door latches. To do so, open the coin mech
door. Located inside, above and to the right and left of
the coin mech, are two monitor door latches. Unsnap the
monitor door latches and lift the door upwards. See
Figure 9.
To gain access to the entire surface of the monitor
screen on the cabaret model, you will have to release
the monitor door latches. To do so, open the coin mech
door. Located inside, above and to the right and left of
the coin mech, are two monitor door slide-latches.
Loosen the thumb nuts securing the latch and slide the
latch open. Pull up on the bottom of the bezel to
remove it (NOTE: TO FULLY REMOVE THE BEZEL,
YOU MUST DISCONNECT THE GROUND BRAID).
See Figure 6.
To gain access to the entire surface of the monitor
screen on the countertop model, you will have to
remove the top of the machine. To remove the top of
the machine, unlock and open the rear door. Locate the
thumb nuts holding the lock brackets on each side of
the monitor shelf. Unscrew and remove the thumb nuts
and push the top forward. Pull upwards on the top to
remove it from the machine. See Figure 5 for lock
bracket locations.
NOTE: DO NOT USE ANY ABRASIVE SOLVENTS, ACID OR
VINEGAR-BASED CLEANSERS ON THE MONITOR OR
SIDE DECALS. SUCH CLEANSERS COULD HARM THE
TOUCHSCREEN AND ERASE THE DECALS OVER
TIME. BE CAREFUL NOT TO USE COMMERCIAL
CLEANERS CONTAINING ANY OF THESE
SUBSTANCES.
Troubleshooting
Security Key Error Messages
“KEY NOT VALID” message means the security key
is missing
“KEY QUESTION SET ERROR” message means the
security key does not match the
chip set.
Coin Jam
The game also has coin jam and stringing detection
software. Should a coin become jammed in the mech
or someone tries to string the mech, a continuous tone
will be emitted by the game.
If the game emits the coin jam indicator sound when
powered up, this may indicate that the NORMALLY
CLOSED contacts of the coin mechanism are being
used. The NORMALLY OPEN contacts must be used.