SET MID LEVEL
1.
Your blind battery requires charging approx every 6 months*. When your blind starts to run
slowly, the battery needs to be charged.
*This can vary depending on size of the blind, weight of the fabric and the amount of useage.
2.
Connect the supplied recharger, and charge the battery for 5-6 hours.
3.
The recharger light will turn from
RED
to
GREEN
when charged. When the light turns green
we recommend charging for a further hour to ensure a full charge.
CHARGING
GROUPING
20.
To set a mid level, run the blind to the desired position using the buttons on the
remote control.
21.
Press and hold both “L” and until the motor JOGS ONCE (TIP: Press “L” button on the
back of the remote first). The mid level position is now set.
22.
When the blind is in the upper or lower level positions only, press the button for the blind
to cycle to the mid level position.
23.
Program each blind as per standard programming instructions (steps 1-22).
Select which blinds are to be grouped. (We recommend grouping a maximum
of 5 blinds per channel).
For each blind to be grouped:
24.
Firstly, press and hold the
RED
button on the motor until the motor JOGS THREE times.
This breaks any link to a remote, but keeps the limits already programmed.
25.
Press and hold the
RED
button on the motor until the motor JOGS ONCE.
26.
If using a multichannel remote, select which channel is to be used.
(Skip this step if using a single channel remote).
27.
Press the “C” button on the back of the remote to link the remote to the motor.
28.
Repeat steps 24-27 for remaining blinds that are to be grouped.
29.
Once you have grouped all your blinds, using the or buttons on your remote control
will operate all selected blinds together. The individual limit presets of each blind will
be retained.
SET UPPER LEVEL
15.
Press button on the remote control. The blind will begin to rise.
16.
When the blind is nearing the preferred upper level press the button on the remote control.
17.
Press the buttons to accurately position the upper level.
18.
When the blind has reached the correct position, press “C” on the back of the remote control.
19.
The motor will JOG ONCE to confirm level position is set. This concludes the upper level
setting. The motor has now exited LEVEL SETTING MODE.
PROGRAMMING INSTRUCTIONS
