Page 22
MERIDA USERS MANUAL
3. Grasp the handle (figure 33, A), tilt the battery pack for-
ward (figure 33, B) and lift it from the frame (figure 33, C).
4. Refer to Section 6c - 6e for charging instructions.
5. Refer to section 6i below for storage instructions.
b.Installing the battery pack
1. Be sure the key is turned to the “OPEN” position (figure
30, D).
2. Set the front edge of the battery pack on the frame (D1)
and align the cutout (D2) with the seat tube.
3. Tilt the battery pack rearward until the contacts in the
battery rest on the terminals (figure 33, E) in the frame.
4. Press down and lock the battery pack into place by turn-
ing the key clockwise to the “OFF” position. The locking
pin should engage the striking plate (figure 34, A). You
may need to wiggle the pack to get the locking pin to
engage the striking plate. Lift up on the handle to be
sure the battery pack is securely locked before riding
the bike.
WARNING: Study figure 34 to see the difference
between correct (B) and incorrect (C) Battery Pack
attachment.
5. Press down on the outside edge of the black key cap to
fold the cap against the battery pack (figure 32, A). This
will prevent your leg from hitting the key while riding.
WARNING: Before each ride you need to verify that the
battery pack is securely attached to your bicycle. If the
pack isn’t properly attached it may fall off the bike
causing injury and damage to the battery pack and
bicycle
6i. BATTERY PACK STORAGE
Before storing, charge the battery to its maximum capac-
ity. The battery will discharge automatically and completely
after two months. If you store the battery for longer than
two months without charging, recharge to maximum ca-
pacity to continue storage, or before attempting to use the
battery as a power source for MERIDA PowerCycle™.
CAUTION: Leaving the battery in a discharged state
may affect the long-term life of the battery. Always store
your MERIDA PowerCycle™ battery fully charged, in
the“OFF” position.
CAUTION: Store the battery in a cool, dry, level, secure
area with good ventilation and away from any heat
source. If storing your MERIDA PowerCycle™ with battery
in place, turn Battery Key Switch to“OFF” position.
Leaving Battery Key Switch in the“ON” position while
stored or parked will result in more rapid battery
discharge.
6j. TRANSPORTING YOUR BICYCLE
When transporting your MERIDA PowerCycle™, it is best to
remove the battery, as it is easier to lift and maneuver the
bicycle. When transporting your bike it is best to cover the
battery compartment to prevent dirt and other foreign
matter from getting into the housing.
WARNING: Keep the battery pack and charger away
from water to prevent electrical shock and damage to
the charger or batteries.
CAUTION: Do not lay your MERIDA PowerCycle™ on
its side, as doing so can cause damage to the control
components, motor housing, pedals, crank arms, and
wheels.
6k. BATTERY CARE and MAINTENANCE
There are no user-serviceable parts in the battery. If you
suspect a problem, take your MERIDA PowerCycle™,
charger and battery to your MERIDA Dealer.
MERIDA PowerCycle’s™ Lead Acid (LA) battery can be
charged over 300 times and Nickel Metal Hydride (NiMH)
can be charged over 500 times before the capacity drops
below 80% of original (with good care according to the
instructions in this manual).
Remove the battery pack before washing your PowerCycle™.
Clean the PowerCycle™ with a mild soap and a sponge. DO
NOT use a power hose or washer. Gently rinse with water.
Avoid spraying water directly onto the battery level indica-
tor, control switches, motor, and the front or rear hub bear-
ings. Do not spray water directly at the battery junction (fig-
ure 33,E) on the frame. Dry the
frame-mounted electrical ter-
minals, with a non-abrasive
cloth at the battery junction
before reinstalling the battery
pack. Use automotive wax to
protect painted surfaces. Lu-
bricate the chain periodically
to help prevent corrosion and
minimize wear.
CAUTION: Please read the following general safety
tips for care and maint enance of your MERIDA
PowerCycle’s™ battery pack:
•
Do not place battery into a fire or near intense heat source
as it can explode and cause serious injury or death.
•
When cleaning the battery pack’s casing, use a dry cloth
only. Do not use solvents or cleaning solutions of any
kind.
