VESSELVIEW 703
90-8M0124492 eng MARCH 2017
© 2017 Mercury Marine
Page 3 / 6
2. Secure the VesselView with the appropriate size mounting screws. Use the supplied alignment tool when driving the
mounting screws, this will properly align the screws to ensure that the bezel will seat securely to the unit. Do not
overtighten the screws.
a -
Maximum of 5.5 mm (0.22 in.)
b -
Maximum of 2.2 mm (0.09 in.)
c -
Use a screwdriver
d -
Proper screw seating
e -
No use of power drivers
f -
Improper mounting hardware
3. Installing the bezel and removal: When fitting bezels, ensure that the hook tabs on the back of each bezel recess into
opposing slots on the screen frame. Once flush with the front surface of the screen, slide the top bezel to the left, and the
bottom bezel to the right to lock them into place. The bezel trim has been designed to be low profile, and therefore fully
conceal the locking tabs that keep it from being accidentally disengaged from the mounting flange. To remove the bezel
trim, slide it sideways; to the right for the top bezel and to the left for the bottom bezel.
63006
Bezel install; opposite for removal
DTS Wiring Guidelines
!
WARNING
Splicing or probing will damage the wire insulation allowing water to enter the wiring. Water intrusion may lead to wiring
failure and loss of throttle and shift control. To avoid the possibility of serious injury or death from loss of boat control, do
not splice or probe into any wire insulation of the DTS system.
•
Never attempt to connect, network, tie into, switch, sink source voltage or current from the DTS wiring harnesses.
a
b
c
d
e
f
62845
