Mercury KOB KM266 FDSMx, Руководство пользователя

Страница: 31 / 44

3: BIOS Setup Utility
Floppy Drive
Seek
If you enable this item, your system will check all
floppy disk drives at start up. Disable this item
unless you are using an old 360KB drive.
PS/2 Mouse
Support
If this item is set to Enabled, the onboard PS/2
Mouse port will work. Setting this to Disable turns off
the port.
Primary Display This item determines the display devices for the
primary display of your computer.
Password Check If you have entered a password for the system, use
this item to determine, if the password is required to
enter the Setup Utility (
Setup ) or required both at
start-up and to enter the Setup Utility ( Always ).
Boot to OS/2 >
64MB
Enable this item if you are booting the OS/2
operating system and you have more than 64MB of
system memory installed.
L1/L2 Cache Leave these items enabled since all the processors
that can be installed on this board have internal
cache memory.
System BIOS
Cacheable
If you enable this item, a segment of the system
BIOS will be cached to main memory for faster
execution.
SDRAM Timing
by SPD This item enables or disables the SDRAM timing
defined by the Serial Presence Detect electrical.
SDRAM
Frequency
This item determines frequency of SDRAM memory.
SDRAM CAS#
Latency This item determines the operation of SDRAM
memory CAS (column address strobe). It is
recommended that you leave this item at the default
value. The 2T setting requires faster memory that
specifically supports this mode.
SDRAM Bank
Interleave
Enable this item to increase SDRAM memory
speed. When enabled, separate memory banks are
set for odd and even addresses, and upcoming byte
of memory is accessible while refreshing the current
byte.
AGP Mode This item provides the OnBoard VGA mode with
three options of 1,2, 4 multiplied frequency.
AGP Comp.
Driving
This item signals the auto or manual driving current
on AGP cards. Some AGP cards need stronger
driving current for operation. We recommend you
set this item to be default value.
27