Section 2 - On the Water
90-8M0093150
eng
MAY 2014
Page 29
NOTE: The joystick must move over 50% of its travel for the movement to be recognized as input. A beep will sound.
24707
Adjusting heading to starboard
To Resume a Heading
The resume light is on if the previous course heading is available to resume.
IMPORTANT: The previous heading can only be resumed within four minutes of the auto heading being disengaged by turning
the wheel past the detent or if the vessel has been turned no more than 90°.
Press the resume button to resume the previous heading, if you turned the steering wheel and disengaged auto heading.
Disengaging Auto Heading
1. Disengage the auto heading mode with any of the following actions:
•
Place the ERC handles for all engines in neutral. The auto heading light turns off and the standby light comes on.
•
Turn the steering wheel beyond the electronic detent. The auto heading light turns off and the resume light comes on.
•
Press the auto heading button on the autopilot trackpad. The auto heading light turns off and the standby light comes
on.
2. A single beep sounds and the VesselView display will turn gray, showing that the mode is in standby.
3. If the resume light is on, you can press
RESUME
to resume the course in auto heading. Refer to
To Resume a Heading
. If
you do not wish to resume the course, press the auto heading button once to enter standby mode.
51883
4. If the standby light is on and the resume light is not, you cannot resume your course by pressing the resume button. Refer
to
To Resume a Heading
. Press the auto heading button to fully exit the auto heading mode.
