www.avsl.com
450.007UK User Manual
3.
Next push the L-shaped lock screw (17) through the assembly and into the thread at the bottom of the telescopic
stand (13). Tighten firmly, but do not overtighten.
4.
Loosen the height adjustment screw (12) and pull the inner tube out from the telescopic stand to the desired
height, then retighten the screw.
Attaching the motor housing to the stand base (see Fig. 2):
1.
First remove the pivot screw (7) and the bolt (20) from the top of the telescopic stand, then remove the neck
retaining screw (8) and small adjustment screw (19) from the motor housing bracket.
2.
Place the motor housing on the top of the stand and thread the large pivot bolt (20) through the bracket. Screw in
the small retaining screw (8) and tighten, but do not overtighten.
3.
Fit the large pivot screw (7) onto the end of the bolt (20) and the small adjustment screw (19) at the other side
above the bolt. Tighten the screws while holding the fan motor upright.
Assembling the fan blade and grilles (see Fig. 3):
