FUEL AND OIL
eng
43
Oil Recommendation
Recommended Oil
Mercury or Quicksilver Premium 2
‑
Cycle TC
‑
W3
Outboard Oil
IMPORTANT: Oil must be NMMA certified TC‑W3 2‑Cycle oil.
Mercury or Quicksilver Premium TC‑W3 2‑Cycle oil is
recommended for this engine. For added protection and
lubrication, Mercury or Quicksilver Premium Plus TC‑W3 2‑Cycle
oil is recommended. If Mercury or Quicksilver outboard oil is not
available, substitute another brand of 2‑cycle outboard oil that is
NMMA Certified TC‑W3. Severe engine damage may result from
use of an inferior oil.
Mixing Fuel and Oil
Use a 1:25 oil/gasoline mixture in the first tank of fuel.
After the break‑in fuel mixture is used up, use a 1:50 oil/gasoline
mixture. Refer to the table (following) for mixing ratios.
GASOLINE/OIL MIXING RATIO CHART
OIL/GASOLINE MIXING RATIO CHART
Oil/Gas
Ratio
3.8 liters (1 gal)
gas
11.5 liters (3 gal)
gas
23 liters (6 gal) gas
1:25
148 ml (5 fl oz) oil
473 ml (16 fl oz) oil 946 ml (32 fl oz) oil
1:50
89 ml (3 fl oz) oil
237 ml (8 fl oz) oil
473 ml (16 fl oz) oil
MIXING PROCEDURE
Pour the full amount of oil along with approximately one gallon of
gasoline into an approved container. Shake the two together until
they are thoroughly mixed. Add the remainder of gasoline and
shake container to ensure mixing.
Engine Break‑In
Engine Break
‑
In Fuel Mixture
Use a 1:25 oil/gasoline mixture in the first tank of fuel.
Engine Break
‑
In Procedure
Refer to
Operation
‑
Engine Break
‑
In Procedure
for correct
break‑in procedure.
Содержание 4.9 TwoStroke
Страница 4: ...iv eng...
Страница 93: ...ACCESSORIES eng 85 Parts packaged with engine Fuel tank 12 L 1 5B D only Primer bulb 1set 5B D only...
Страница 94: ...ACCESSORIES 86 eng Optional Accessories 41075 a b c d e f g h i j...
Страница 96: ...ACCESSORIES 88 eng Wiring Diagram 41076 a b c d f e g h i j k l...