Mercury 4.3 TKS series, Руководство по эксплуатации и техническому обслуживанию, Страница: 48 / 109

Section 4 - Maintenance
Page 40 90-8M0113857
eng
DECEMBER 2015
d. Drain the fluid into a suitable container.
a - Oil fill and drain screw
b - Sealing washer
5. All other models:
a. Place the sterndrive unit in full trim out position.
b. Remove the oil fill and drain screw and sealing washer.
c. Drain the fluid into a suitable container.
a - Oil fill and drain screw
b - Sealing washer
6. Remove the oil vent screw and sealing washer. Allow the oil to drain completely.
a - Oil vent screw
b - Sealing washer
IMPORTANT: If any water drains from the unit, or if the fluid appears milky, the sterndrive unit is leaking. See your
authorized Mercury MerCruiser dealer.
7. Lower the sterndrive unit so the propeller shaft is level.
IMPORTANT: Use only Mercury/Quicksilver High Performance Gear Lubricant in the sterndrive unit.
8. Fill the sterndrive unit through the oil fill and drain hole with specified gear lubricant until an air‑free stream of lubricant
flows from the oil vent hole.
Tube Ref No. Description Where Used Part No.
87
High Performance Gear Lubricant Sterndrive unit 92-858064K01
9. Install the oil vent screw and sealing washer.
10. Continue to pump gear lubricant into the drive through the oil fill and drain hole until gear lubricant appears in the gear lube
monitor.
11. Fill the monitor so that the oil level is in the operating range. Do not overfill.
12. Ensure that the rubber gasket is inside the cap and install. Do not overtighten.
mc79506-1
a
b
b
a
mc79507-1
mc77106-1
b
a