350.117UK User Manual
Un-programming a socket
from a remote is also possible by unplugging the socket from the mains.
Press and hold the program/on/off button on the side of the socket while plugging it back in, keep the
button pressed for around 5 seconds until the LED indicator begins to flash. Finally release the button to
finish the reset and the LED indicator should stop flashing.
Troubleshooting:
•
If the socket is unresponsive to the remote control, please refer to the
Un-programming a socket
and
Re-programming
operation sections in the manual above.
•
If sockets are not responding correctly or the LED indicator on the remote control becomes dim, then
the battery should be changed at the earliest possible opportunity. Install the 12V (23A) battery in
the battery compartment; making sure the polarity is the correct way around. Always dispose of old
batteries with consideration for the environment.
•
Make sure the socket and device are properly connected and powered on.
•
Make sure that the socket is placed in an area with proper air circulation without overheating.
Warning:
•
For reasons of electrical safety, this socket must never be immersed in water, exposed to damp
conditions or excessive force.
•
Do not use this product if you find that it is damaged in any way.
•
Never exceed the maximum load current.
•
Do not attempt to repair this product or take it apart under any circumstances, as this will invalidate
your warranty.
This product is classed as Electrical or Electronic equipment and should not be disposed with other household or
commercial waste at the end of its useful life. The goods must be disposed of according to your local council guidelines.
Errors and omissions excepted.
Copyright© 2021 AVSL Group Ltd, Unit 2 Bridgewater Park, AVSL (Europe) Ltd, Unit 3D North Point House,
Taylor Road, Trafford Park, Manchester. M41 7JQ.
North Point Bus. Park, New Mallow Road, Cork, Ireland.
