Mercury 10 EFI FourStroke, Инструкция по установке, эксплуатации и обслуживанию

Страница: 82 / 139

AFTER EACH USE
• Flush the outboard cooling system with fresh water if operating in salt or
polluted water. Refer to
Flushing the Cooling System
.
• Wash off all salt deposits and flush out the exhaust outlet of the propeller
and gearcase with fresh water if operating in saltwater.
• If operating in saltwater, inspect the powerhead and powerhead
components for salt buildup. Refer to
Cleaning Care
Recommendations
.
EVERY 100 HOURS OF USE OR ONCE YEARLY, WHICHEVER
OCCURS FIRST
• Change engine oil and replace the oil filter. The oil should be changed
more often when the engine is operated under adverse conditions, such
as extended trolling. Refer to
Engine Oil
.
• Change the gear lubricant. Refer to
Gearcase lubricant
.
• Check water‑separating fuel filter for contaminants. Replace filter if
required. Refer to
Fuel System
.
• Remove the propeller and lubricate the propeller shaft. Refer to
Propeller
Replacement
.
• Check corrosion control anodes. Check more frequently when used in
saltwater. Refer to
Corrosion Control Anodes and Continuity Wire
.
• Drain and replace gearcase lubricant. Refer to
Gearcase Lubricant
.
• Inspect battery. Refer to
Battery Inspection
.
• Saltwater usage: Remove and inspect spark plugs for corrosion and
replace as necessary. Apply Anti‑Seize Compound only onto the threads
of spark plug prior to installation. Refer to
Spark Plug Inspection and
Replacement
.
Tube Ref
No.
Description Where Used Part No.
81
Anti-Seize
Compound
Spark plug threads 92-898101389
• Add Quickleen to the fuel tank.
Tube Ref
No.
Description Where Used Part No.
Quickleen Engine &
Fuel System
Cleaner
Fuel tank 8M0047931
• Check cowl seals to ensure seals are intact and not damaged.
• Check that the idle relief muffler is in place, if equipped.
• Inspect the thermostat visually for corrosion or a broken spring. Verify the
thermostat closes completely at room temperature—dealer service.
MAINTENANCE
72
eng