Mercury Security © 2019
MR62e
DOC 10107-0057
REV 1.02
Page 1
www.mercury-security.com
2355 MIRA MAR AVE. LONG BEACH, CA 90815-1755, (562)986-9105 FAX (562) 986-9205
MR62e OSDP Reader Interface
Installation and Specifications
1. General:
The MR62e OSDP reader interface provides a network connected interface to control two physical barriers
using OSDP readers and provides a solution for the OEM integrator for interfacing to OSDP readers and
door hardware. The on-board Ethernet with PoE/PoE+ support enables easy installation. The MR61e
supports up to four OSDP readers configured as paired or alternate readers.
Note: For UL, the Power Sourcing Equipment (PSE) such as a PoE/PoE+ enabled network switch and/or
PoE/PoE+ power injectors must be UL Listed under UL294B.
One serial 2-wire RS-485 communication port is available that can accommodate up to four OSDP
readers. Four Form-C relay outputs may be used for door strike control or alarm signaling. The relay
contacts are rated at 2 A @ 30 Vdc, resistive and are in a dry contact configuration. Six inputs are provided
that may be used for monitoring the door contacts, exit push buttons, and alarm contacts. Input circuits
can be configured as unsupervised or supervised. The MR62e requires PoE, PoE+ or local 12 Vdc for
power. The MR62e may be mounted in a 3-gang switch box; a mounting plate is supplied with the unit or
be mounted in an enclosure; the supplied mounting plate has mounting holes that match the MR50
mounting footprint.
2. MR62e Hardware:
MR62e Layout
TB
5
1
IN1
IN2
IN3
IN4
IN5
IN6
VO
GN
D
V
IN
GN
D
V
IN
POE
J5
NO
NC
2
-C
NO
NC
1
-C
NO
NC
4
-C
NO
NC
3
-C
K1
K2
K3
K4
K4
K3
K2
K1
RVO
GND TR- TR+
J3
J4
J1
1
05
19
-0
00
0-
F, RE
V-A
7
6
5
4
3
2
1
2
3
4
1
S1
ON
|
|V
INPUTS
RELAYS
J5: INPUT
POWER
SELECT
12 Vdc IN &
AUX POWER
OUTPUT
2
.55
[6
4
.7
7
]
2
.55
[6
4
.7
7
]
5
.4 [
1
3
7
.1
6
]
STATUS
LEDs
2.35 [59.69]
2.75 [69.85]
.2 [5.08]
S1: DIP
SWITCH
J3: TAMPER
SWITCH
TO OSDP
READERS
LINK
(GREEN)
SPEED
(YELLOW)
J4: TIA-485
TERMINATION
JUMPER
Ø.125 [3.18]
6 PLACES
EARTH
GROUND
J1: ETHERNET RJ45
CONNECTOR
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
