10/10/2016
GYROLED® M130
MAGNETIC MOUNTING
GT-0656-FEUX Ind A
Siège social/Head-quarters
: Zone d’Activités « Les Gailletrous » - rue Louis Pasteur- 41260 LA CHAUSSEE SAINT VICTOR
Tel : 00 33 (0) 2 54 57 52 52
– Fax 00 33 (0) 2 54 56 80 00
SAS au capital de 102. 400 € - APE (NAF) 2790 Z – SIRET 310 999 891 00040
Page 2
30104-00
PROGRAMMABLE MODELS
13 flash patterns
1. Rotating R65
2. Double Flash R65
3. Triple Flash
4. Single Flash
5. ½ Rotating
6. ½ Double Flash
7. ½ Triple Flash
8. ½ Single Flash
9. ICAO Flash
10. ICAO Rotating
11. ½ ICAO Flash
12. ½ ICAO Rotating
13. Top central LED on only
The GYROLED® M130 is R65 approved in Blue,
Amber and Red colours only.
A. Cigar Lighter spiral cable
B. Cigar Lighter Plug
C. Button : Flash pattern selection
D. Switch with red LED : GYROLED® ON /OFF button
E. Vehicle Cigar Lighter Plug
GYROLED® M130 BLUE : 29619
GYROLED® M130 AMBER : 29620
GYROLED® M130 WHITE : 29621
GYROLED® M130 RED : 29622
GYROLED® M130 GREEN : 29623
The Gyroled M130 installation on the vehicle should be done in compliance with the specific current regulations regarding
emergency and service vehicles special lighting. The beacon flash pattern choice must also meet these requirements.
The installer is therefore fully responsible for the product installation and flash pattern chosen.
Do not handle the GYROLED® M130 immediately after use, to avoid burning the hands, as the aluminum base may still
be hot.
Do not stare directly at the GYROLED during operation, so as to avoid eye damage.
The Gyroled® M130 position on a roof vehicle must be chosen with regard to the roof panel and its power supply. The
M130 Gyroled® must be mounted so as to be seen at 50 meters in all directions on the horizontal plane.
BE CAREFUL WITH THE MAGNETS RUBBER MEMBRANES
Any alteration to the adherence of the rubber greatly reduces the Gyroled® fixing properties. This may cause the
Gyroled® to come off or tear during use.
Before putting the Gyroled® M130 on the vehicle roof, ensure the good condition of the surface on which the magnetic
pads will be based. This surface must be flat and clean to ensure optimum contact between the pads and the roof panel.
Clean the roof panel if necessary. It must also be conducive to magnetic mounting. Polyester and derivative panels are
not compatible.
WARNING
NEVER EXCEED THE SPEED OF 130 KM/H WITH A MAGNETIC GYROLED M130
MOUNTED ON THE ROOF OF THE VEHICLE
BEYOND THIS LIMIT, AERODYNAMIC PRESSURE MAY SUDDENLY REMOVE
THE GYROLED® M130 FROM THE ROOF PANEL.
