MerCruiser Sterndrive TDI 3.0L, Руководство пользователя

Страница: 72 / 119

Section 5 - Maintenance
Page 64 90-8M0070851
eng
AUGUST 2012
3. Add the specified fluid to bring the fluid level to within the "MIN" and "MAX" lines on the reservoir.
a - Reservoir
b - "MIN" and "MAX" lines
Tube Ref No. Description Where Used Part No.
114
Power Trim and Steering
Fluid
Power trim pump 92-858074K01
4. Install the fill cap.
Changing
Power trim fluid does not require changing unless it becomes contaminated with water or debris.
Power‑Assisted Steering Fluid
The power steering fluid level should be checked at regular intervals.
IMPORTANT: Do not leave the steering wheel at full lock for longer than 15 seconds with the engine running. The power
steering fluid will heat up considerably when the steering wheel is at full lock and could cause damage to the power steering
system.
When the steering wheel is at full lock, power steering pump noise will increase as the pump is under full load and the engine
idle RPM will be reduced momentarily.
Checking
1. Center the sterndrive and stop the engine.
2. Remove the fill cap and dipstick from the fluid reservoir and observe the level.
a - Power steering fluid reservoir
b - Fill cap
IMPORTANT: If fluid is not visible in the fluid reservoir, see your Mercury Diesel authorized repair facility.
Filling
1. Remove the fill cap/dipstick and wipe with a clean cloth.
2. Screw the fill cap/dipstick completely into the power steering fluid reservoir.
3. Remove the fill cap/dipstick from the reservoir and observe the fluid level.
a
b
7876
a
b
50636