mercor mcr 9705, Руководство пользователя

Страница: 7 / 24

Smoke and Heat Exhaust Control Unit mcr 9705
– User Instruction Manual
Strona 7 z 24
Above the RESET pushbutton there are jumpers regulating the vent’s opening time in
ventilation and entrance mode (combinations of settings can be found in Chap. 3.2):
No. Description Function
46 H6 depending on the combination created with the H5 jumper
47 H5 depending on the combination created with the H6 jumper
Along the top edge of the module's PCB there are terminal strips which are used to
connect the system’s elements:
No. Description Function
28 P6 Input for ventilation (U-up, D-
down, ┴ - joint, closing
contacts)
29 P7 input for wind/rain controls (closing contact)
30 P8 output for actuators (-,+)
31 P9 RPO(+,-) pushbutton line
32 P10 control input from ROP-1 (R,U)
33 P11
sensor’s line (+,-)
34 P12 power supply of the alarm signal loop (+, -)
35 P13 external alarm input, 24V= relay
36 P14 alarm indication output - relay contact
37 P15 defect indication output - relay contact
38 P16 programmable / service output (ex. opening the vent/ door
closing) - relay contact
39 P17 RPO-1 indication output (1, 2, 3)
48 P19 power supply for alarm signaling loop (-, +)
Note: For control units designed for the purpose of a smoke curtain, above the elements [30,44]
there is additional 4 poles terminal strip for
mcr PROSMOKE CE/CE1 curtains’ actuators
.
There are two additional entries in the upper right corner :
No. Description Function
25 P1 key switch input
26 P2 programmable / service input
Moreover,
in the lower right corner there are:
No. Description Function
40 P4 positive pole of the battery
41 P5 negative pole of the battery
On-board fuses:
No. Description Function
43 FS1 batteries protection (6.3 A or 8 A
*
quick)
44 FS3
actuator’s line protection (6.3 A or 8 A
*
quick)
230 V 50 Hz power supply is connected to the terminal strip (42) in the top left
corner of the assembly board (inside the control unit).
Overload circuit breaker FS2 (45)
– C 4 A or 6 A
*
on the assembly board
provides protection for the 230 V mains circuit and the possibility for disconnecting
power supply.