3
OPERATION INSTRUCTIONS
The SW Series Food Warmers may be operated “wet” or “dry”. Operation in either mode is a matter of personal preference
in product moisture content, consistency and convenience. Some experimentation will help in determining which type of
operation is best suited to your needs.
“Dry” Operation
1.
Place product (buns), without removing the original packaging, directly into drawer.
2.
Set
Moisture Control
to “High” closed) position.
3.
Set
Main Power Switch
to “On” position.
4.
Set
Temperature Control
to #5. (Note: This is an average setting. Due to product diversity, some experimentation
will be necessary to obtain desired results).
5.
Moisture trapped in packaging will keep product fresh.
“Wet” Operation
1.
Remove bun screen from drawer to access water pan. Fill water pan with approximately 2 quarts of warm water.
Replace bun screen.
2.
Remove product from original packaging and place in drawer.
3.
Set
Moisture Control
midway between High and Low.
4.
Set
Main Power Switch
to “On” position.
5.
Set
Temperature Control
to #5. (Note: This is an average setting. Due to product diversity, some experimentation
will be necessary to obtain desired results).
6.
To lower temperature of warming drawer, rotate temperature control knob to a lower setting. To increase temperature,
rotate to a higher number.
WARMING HINTS
•
To insure consistent results, always rotate stock when refilling drawer with fresh product.
•
DO NOT
obstruct air space under warmer. This will prevent proper air circulation and cause product inconsistencies.
•
It is
NOT
recommended that you use frozen product. Allow product to reach room temperature before placing in
warmer.
•
If operating the warmer in the
“Wet”
mode, periodically check water level in pan. Replace as needed.
CLEANING INSTRUCTIONS
CAUTION: Unplug unit and allow to cool before cleaning.
The SW Series Food Warmers are designed for easy cleaning. The outer surfaces need nothing more than a daily wiping
with a soft damp cloth. Remove the bottom screen and water pan and rinse in hot sudsy water. Inner surfaces may be
wiped with a soft damp cloth.
Do not use abrasive cleaners on any part of this unit. This will cause damage to the finish of the unit.
