2
BEFORE INSTALLATION
NOTE: Upon receipt of this unit, immediately unpack and inspect for possible concealed
shipping damage. If unit is found to be damaged, save all packing materials and contact your
delivery carrier within 5 days. Refer to “Shipping Damage Instructions” enclosed for detailed
instructions. Failure to follow these instructions will negate Merco/Savory’s or your ability to
file claims and receive compensation for shipping damage.
INSTALLATION INSTRUCTIONS
Install this unit in the most convenient location for ease of cleaning, maintenance and general operation. Avoid installing in
locations with drafts, close proximity to grease or vapor-producing appliances, or other high ambient heat equipment. Allow
approximately 1” clearance on sides and back of unit for proper air circulation. Allow sufficient overhead clearance for
proper heat dissipation. This toaster must be level for proper operation and come equipped with 4” adjustable legs for this
purpose. (See enclosed instruction sheet for details)
Before operating this unit, be sure that the toast receiving tray and product carriers are properly installed:
1.
The toast receiving tray is factory installed in the front delivery position. Check to see if tray slots are securely placed
over protruding pins on inside toaster panels. If rear delivery position is desired, remove tray from front of toaster, and
re-insert from back of toaster making sure slots engage the 2 protruding pins.
2.
To install product carriers, rotate chain until master link is centered at front of toaster. Press one chain to the side so
carrier can engage the first 2 pins directly under the blank space created by the master link on each chain. Make sure
both sides of carrier have engaged parallel pins. Place remaining carriers on chain making sure no space is left
between carriers. Product retainer bars simply slip into holes in carrier.
WARNING
THIS TOASTER MUST BE PLUGGED INTO THE
PROPER VOLTAGE WHICH IS SPECIFIED ON
THE DATA PLATE LOCATED ON THE BACK
PANEL OF THE TOASTER. USE OF ANY OTHER
VOLTAGE OR ALTERING OF PLUG WILL
DAMAGE UNIT, VOID WARRANTY, AND MAY
CAUSE INJURY.
CONTROL PANEL FEATURES
Variable Conveyor Speed Control -
Located at top of control panel, this control regulates the speed of the conveyor belt,
If product is too dark, increase the speed of the conveyor belt. If product is too light, decrease the speed of the conveyor
belt.
Bun/Toast Switch
- Set this switch to “Bun” position for one-sided toasting. Set at “Toast” position for two-sided toasting.
Thermostat Control
- This regulates the heating elements. If the product is too light, rotate knob to a higher number, If
the product is too dark, rotate this know to a lower number. The thermostat will maintain a constant temperature to give
correct toasting heat and color to the product.
On/Off Switch
- Both the conveyor and the heating elements are controlled by this switch.
