Please retain product label and instructions for future reference
03TGCOR0808-V3
Please retain product label and instructions for future reference
01636880514
Dimensions
Depth = 248cm
Width = 248cm
Height = 211cm
For Assistance Please
Contact Customer Care on
01636 880514
2mm Drill bit
x2
Winter = High Moisture = Expansion
Summer = Low Moisture = Contraction
This building should be erected by
two people.
For ease of assembly, it is advisable to
pilot drill all screw holes and ensure
all screw heads are countersunk.
BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY
- Check the pack and make sure you have all the parts listed.
- When you are ready to start, make sure you have the right tools at hand
(
not supplied)
including
a Phillips screwdriver, Stanley knife, wood saw,
step ladder and drill with 2mm bit.
- Ensure there is plenty of space and a clean dry area for assembly.
TIMBER
As with all natural materials, timber can be affected during various weather
conditions. For the duration of heavy or extended periods of rain, swelling of the
wood panels may occur. Warping of the wood may also occur during excessive
dry spells due to an interior moisture loss. Unfortunately, these processes cannot
be avoided but can be helped. It is suggested that the outdoor building is
sprayed with water during extended periods of warm sunshine and sheltered as
much as possible during rain or snow.
Our buildings are delivered pre-treated with a water based timber treatment
however this only helps to protect during transit of your garden item.
To
validate your guarantee and for better protection against weathering
it is
ESSENTIAL
that you treat the garden building with a wood preserver within 3
months of assembly. This will need to be re-applied annually to ensure longevity
of your building. Care must be taken when constructing the garden building
that it is not touching the ground and is on a suitable base.
BUILDING A BASE
When thinking about where the building and base is going to be constructed: Ensure that there will be access to all sides for maintenance work and
annual treatment.
TYPES OF BASE
- Concrete 75mm laid on top of 75mm hard-core.
- Slabs laid on 50mm of sharp sand.
Ensure the base is level and is built on firm ground, to prevent distortion. Refer to diagrams for the base dimensions, The base should be slightly
smaller than the external measurement of the building, i.e. the cladding should overlap the base, creating a run off for water. It is also recommended
that the floor be at least 25mm above the surrounding ground level to avoid flooding.
2440x1400mm 2440x1030mm
1460x2515mm 1060x2515mm
Before assembly
please make sure you have a
suitable base ready to erect your
building
MADE IN GREAT BRITAIN
1720x600mm
1720x600mm
3x Front/Side Fascia- 60 x 1485mm
2x Rear Fascia- 60 x 2516mm
Fascia
2x Front Cover Trim- 45 x2055mm
2x Side Cover Trim- 30 x2055mm
Strip
Door Panel
Window Panel
Rear Panel Right
Rear Panel Left
Floor
1x Roof bar- 45 x 2633mm
1x Roof Support block- 32 x 210mm
Framing
1x Rear Panel Framing- 30 x 1918mm
Fixing Kit
1
2
3
4
5
6
7
8
Angled Floor
P1
P2
P3
P4
P5
P6
Roof
Angled Roof
P7
P8
1x Rear Roof Framing- 32 x 2450mm
1x Front Roof Framing- 32 x 1411mm
9
Slave Door
P9
Master Door
P10
Whilst all products manufactured are made to the highest standards of safety and in the case of childrens products independently tested to EN71 level, we
cannot accept responsibility for your safety whilst erecting or using this product.
