P6
1
2
3
50mm
50
mm
50mm
3020mm
1000mm
1420mm
50
mm
Cut three strips from roll of felt,
2x3020mm and 1x1420mm in length.
Place felt on top of roof sheet and
align as shown in diagram ensuring
strip 3 over hangs the front by 50mm.
with equal spacing at each corner.
Ensure strip 1 is the first piece placed
down then lay sheet 2 and then 3 on
top. make sure each sheet overlaps
the next creating a run off.
use a fascia as a guide to mark out the
angled cuts including 50mm
overhang.
Cut the sides as shown in diagram at
the dotted lines, use fascia width as a
cutting guide. Cut Triangle with 50mm
overhang again using fascia as a
guide.
Fix roof to building as shown in step 7,
then place sheets back into position in
diagram with 50mm over hang all
around. fix each sheet using felt tacks
along where sheet overlap.
Step 9
Place the roof section on top of
builidng, ensure roof framing
slots over each side.
Fix the roof sheet into position
using 40mm screws ensuring
that they line up with the
vertical framing inside the
building and along the length
of the internal roof support
bar.
*It is recommended
to cut the felt sheets
before fixing the roof
to building.
21x40mm screws
Step 10
100x10mm felt tacks
17
Fron
t
Corner
Corner
Triangle
Step 11
Fix the cover trims as shown
using 3x 40mm screws per
strip.
45 x 1900mm
30 x 1912mm
Fit the fascias to the
building over the felt
and secure in place with
40mm screws as shown.
Pre drill to avoid
splitting.
Make sure the fascias at
the back of the building
fit lower than the roof
height to allow water to
run of.
12x40mm screws
3
4
4
2
2
5
5
Step 12
17x40mm screws
1
1
