Mercedes-Benz Sprinter, Руководство по эксплуатации

Страница: 265 / 354

Jack support point, rear axle (example: panel
van and crewbus up to 4.0 t)
Jack support point, rear axle (vehicles 5.0 t)
#
Place the jack beneath the jack support point.
#
Vehicles with all-wheel drive: turn jack spindle
2 counter-clockwise as far as it will go.
#
Raise the vehicle until the tire is raised a maxi-
mum of 1.2 in (3 cm) off the ground.
#
Loosen and remove the wheel ( / page 263).
Removing a wheel
Requirements:
R
The vehicle is raised ( / page 261).
When changing a wheel, avoid applying any force
to the brake discs since this could impair the level
of comfort when braking.
* NOTE Damage to threading from dirt on
wheel bolts
#
Do not place wheel bolts in sand or on a
dirty surface.
#
Unscrew the wheel bolts or nuts with the wheel
nut wrench.
#
On front wheels with wheel nuts, remove the
wheel nut cover.
#
Remove the wheel.
Installing a new wheel
Requirements:
R
The wheel is removed (
/
page 263).
&
WARNING Risk of accident from losing a
wheel
Oiled, greased or damaged wheel bolt/wheel
nut threads or wheel hub/wheel mounting bolt
threads can cause the wheel bolts/wheel nuts
to come loose.
#
Never oil or grease the threads.
#
In the event of damage to the threads,
contact a qualified specialist workshop
immediately.
#
Have the damaged wheel bolts or dam-
aged hub threads replaced.
#
Do not continue driving.
&
WARNING Risk of injury from tightening
wheel bolts and nuts
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip.
#
Only tighten wheel bolts or wheel nuts
when the vehicle is on the ground.
* NOTE Damage to electronic components
due to use of installation tools
Vehicles with tire pressure monitoring system:
electronic components are located in the
wheel.
#
Do not place any installation tools in the
area of the valve.
#
Only have tires replaced at a qualified
specialist workshop.
#
Observe the information on the choice of tires
( / page 258).
Wheels and tires 263