should free up the door moulding from the body to allow you to route the cable down the rear seat and up
the lower “A” pillar plate. Refer to the WIS for removal instructions.
You will be installing the Splitter and one end of the GPS antenna coax to this plate located on the right C-
pillar. There are two antenna connections there already. The GPS antenna was the lower one on my
vehicle (red arrow but you should trace the cable back to the antenna first to verify which one is which.
Install the GPS Splitter on the antenna coax mounting plate (there are two holes for it already … blue
arrows) by just snapping it in place:
Disconnect the GPS connector and plug the antenna lead to the bare connector, then connect the part you
just removed (TeleAid coax, red band near connector) to the red connector. The GPS antenna coax mounts
to the black connector and when you are done everything should look similar to this:
