%
Depending on the temperature, the fan and
battery cooling system may audibly switch on
during the charging process.
%
If the vehicle is left idle for long periods and
connected to the alternating current mains
supply (mode 2/3), the high-voltage battery
will be recharged automatically as needed or
when electrical consumers are activated (e.g.
pre-entry climate control).
Ending the charging process
Requirements:
R
The vehicle is unlocked.
#
Press charging interruption button
3
.
The charging process is ended after a short
time. If the
%
indicator lamp
2
then lights
up white, the vehicle socket is unlocked.
%
Instead of pressing charging interruption but-
ton
3
, you can press the
%
button on the
key four times within two seconds.
#
Remove charging cable connector
1
from the
vehicle socket within 30 seconds.
Only after charging with alternating current
(mode 2/3) does the vehicle socket lock again
after a period of 30 seconds, and the charging
process resumes.
%
If you cannot remove the charging cable con-
nector, repeat the unlocking procedure. If the
charging cable connector remains locked,
unlock the charging cable connector with the
emergency release (
/
page 145).
#
Close it, or close the socket cover and charge
socket flap.
#
Remove the charging cable connector from the
mains socket, or from the socket on the wall-
box/charging station, and stow the vehicle
charging cable safely in the vehicle.
%
After the charging cable connector has been
disconnected, the left
%
indicator lamp
2
on the vehicle socket remains lit for some time
before going out.
Unlocking the charging cable connector with the
emergency release
&
WARNING Risk of burns from hot compo-
nents in the engine compartment
Certain components in the engine compart-
ment can be very hot, e.g. the drive system
and the cooler.
#
Allow the drive system to cool down and
touch only the components described
below.
If you must unlock the charging cable connector
mechanically, only touch the following compo-
nents:
R
bonnet
R
emergency release cable
*
NOTE Damaged or dirty vehicle socket
when the socket flap is open
#
Always keep the socket cover and the
socket flap closed when there is no
charging cable connected. This protects
the vehicle socket from dirt and damage.
#
Make sure that the socket cover is
closed properly before closing the socket
flap. This can otherwise result in damage
which may prevent the socket flap from
being opened again.
Driving and parking 145
T447 0414 02
Содержание EQV 2021
Страница 1: ...EQV Owner s Manual T447 0414 02 ...
Страница 7: ...T447 0414 02 ...