Mercedes-Benz EQS 350, Руководство оператора

Страница: 262 / 581

matically maintains a safe distance from the vehi-
cle in front and vehicles cutting in.
Active Stop-and-Go Assist requires you, as the
driver, to keep your hands on the steering wheel
at all times so that you are able to intervene at
any time to correct the course of the vehicle and
keep it in lane.
Observe the notes on driving systems and your
responsibility; you may otherwise fail to recognise
dangers (
/
page 237).
Active Stop-and-Go Assist activates automatically
when all of the following conditions are met:
R
You are in a traffic jam on a motorway or high-
speed major road.
R
Active Distance Assist DISTRONIC is activated
and active (
/
page 254).
R
Active Steering Assist is activated and active
(
/
page 261).
R
You are travelling no faster than 60 km/h.
When Active Stop-and-Go Assist is active the
¬ status display appears in the driver's dis-
play.
System limits
The system limitations of Active Distance Assist
DISTRONIC and Active Steering Assist apply to
Active Stop-and-Go Assist (
/
page 259).
Active Steering Assist
Function of Active Steering Assist
Active Steering Assist is only available up to a
speed of 210 km/h. The system helps you to stay
in the centre of the lane by means of moderate
steering interventions. Depending on the speed
driven, Active Steering Assist uses the vehicles
ahead and lane markings as a reference.
%
Depending on the country, in the lower speed
range Active Steering Assist can use the sur-
rounding traffic as a reference. If necessary,
Active Steering Assist can then also provide
assistance when driving outside the centre of
the lane.
If the detection of lane markings and vehicles
ahead is impaired, Active Steering Assist switches
to passive mode. The system provides no support
in this case.
Permanent status display in the driver's display
Ø
Grey: activated and passive
Ø Green: activated and active
Ø
Red, flashing: prompt to the driver to
actively confirm or transition from active to
passive status, system limit detected
%
During the transition from active to passive
status, the Ø symbol is shown as enlarged
and flashing. Once the system is passive, the
Ø
symbol is shown as grey in the driver's
display.
Contact detection
The driver is required to keep their hands on the
steering wheel at all times and be able to inter-
vene at any time to correct the course of the vehi-
cle and keep it in lane. The driver must expect a
change from active to passive mode or vice versa
at any time.
Driving and parking 259