Mercedes-Benz AMG GT 53 4MATIC+ 2019, Руководство оператора

Страница: 413 / 530

Removing and installing hub caps
Requirements:
R
The vehicle is prepared for a wheel change
(
→
page 410).
Plastic hub cap
#
To remove: turn the center cover of the hub
cap counter-clockwise and remove the hub
cap.
#
To install: make sure that the center cover of
the hub cap is turned counter-clockwise.
#
Position the hub cap and turn the center
cover clockwise until the hub cap engages
physically and audibly.
Aluminum hub cap
#
To remove: position socket 2 on hub cap
1 .
% The socket can be found in the tire-change
tool kit.
#
Position wheel wrench 3 on socket 2 .
#
Using wheel wrench 3 , turn hub cap 1
counter-clockwise and remove it.
#
To install: position hub cap 1 and turn until
it is completely flush with the wheel.
#
Position socket 2 on hub cap 1 .
#
Attach wheel wrench 3 to socket 2 and
tighten the hub cap clockwise.
Specified tightening torque: 20 lb-ft
(27 Nm).
#
Raise the vehicle (
→
page 411).
Raising the vehicle when changing a wheel
Requirements:
R
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
change (
→
page 410).
R
The hub caps have been removed
(
→
page 411).
Important notes on using the jack:
R
Only use the vehicle-specific jack that has
been tested and approved by Mercedes-Benz
to raise the vehicle.
R
The jack is only designed for raising and
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
Wheels and tires 411