G.
Installation of CD Changer
1.
Remove the three (3) transport screws from
the CD changer and install them into the
holding locations in the back of the CD changer
(Figure 17).
2.
Set the suspension spring configuration to
V
(vertical).
3.
Affix the three (3) adhesive dust covers
(contained in the IDENT-KARTE bag) over the
transport screw holes in the bottom of the CD
changer.
4.
Place the IDENT-KARTE in the owner’s
documentation packet.
Figure 17
P82.64-2213-01
5.
Locate the 3-pole electrical connector and fiber
optics in the wheel well.
6.
Mount the CD changer to the bracket with four
(4) M4 x 5 machine screws (Figure 18).
7.
Install the cover by engaging the plastic hinges
over the flange on the top edge of the bracket
and then rolling the hinges toward the back to
lock.
8.
Connect the 3-pole electrical and fiber optic
connectors to the back of the CD changer.
Figure 18
P82.64-2214-01
9.
Lower the CD changer into the wheel well so
that the pin on the bottom of the mounting
bracket fits into the pre-punched opening on the
side member behind the battery (Figure 19).
10.
Continue to position the CD changer so that the
tabs on the mounting bracket align over the
© 2005 Mercedes-Benz USA, LLC
