Mercedes-Benz 2010 GLK 350, Руководство оператора

Страница: 105 / 344

With SmartKey
X
Turn the SmartKey in the starter switch to
position
0.
X
Remove the SmartKey from the starter
switch.
The SmartKey can only be removed from the
starter switch with the automatic
transmission in park position
P.
With KEYLESS-GO
X
Press the KEYLESS-GO start/stop button.
With the driver’s door closed, the starter
switch is now in position
1. With the driver’s
door opened, the starter switch is set to
position
0, same as the SmartKey removed
from the starter switch (
Y
page 76).
If an acoustic warning sounds, you have tried
to turn off the engine with the KEYLESS-GO
start/stop button while the automatic
transmission was not in park position
P.
Read and observe messages that may appear
in the multifunction display (
Y
page 267).
i In an emergency you can turn off the
engine while driving by pressing and
holding the KEYLESS-GO start/stop button
for approximately 3 seconds.
If you have started the engine with the
KEYLESS-GO start/stop button and cannot
turn it off as described above:
X
Remove the KEYLESS-GO start/stop
button from the starter switch.
X
Insert the SmartKey into the starter switch.
The engine turns off. The starter switch is
in position
0 (
Y
page 76).
Automatic transmission
Introduction
For information on driving with an automatic
transmission, see “Driving and parking”
(
Y
page 98).
G
Warning!
Make sure absolutely no objects are
obstructing the pedals’ range of movement.
Keep the driver’s footwell clear of all
obstacles. If there are any floormats or
carpets in the footwell, make sure the pedals
still have sufficient clearance.
During sudden driving or braking maneuvers
the objects could get caught between or
under the pedals. You could then no longer
brake or accelerate. This could lead to
accidents and injury.
! Allow the engine to warm up under low
load use. Do not place full load on the
engine until the operating temperature has
been reached.
Avoid spinning of a drive wheel for an
extended period when driving off on
slippery road surfaces.
This may cause serious damage to the
engine and the drivetrain which is not
covered by the Mercedes-Benz Limited
Warranty.
i
During the brief warm-up, transmission
upshifting is delayed. This allows the
catalytic converter to heat up more quickly
to operating temperature.
Gear selector lever
Gearshift pattern for automatic transmission
j
Park position with gear selector lever lock
k
Reverse gear
Automatic transmission
103
Controls in detail
X204_AKB; 3; 23, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-16T19:16:58+02:00 - Seite 103
Z