Mercedes-Benz 2009 CLK-Class, Руководство оператора

Страница: 346 / 384

Flat tire
344
1
Wheel wrench
X On wheel to be changed, loosen but do not
yet remove the wheel bolts (approximately
one full turn with wrench
1
).
The jack take-up brackets are located directly
behind the front wheel housings and in front
of the rear wheel housings.
G
Warning!
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets.
Make sure the jack arm is fully seated in the
jack take-up bracket.
If you do not position the jack correctly in
the jack take-up bracket, the vehicle can
fall off the jack and seriously or fatally injure
you or others.
! Do not position the jack on the body of
the vehicle, as this may cause damage to
the vehicle.
2
Take-up bracket
3
Jack
4
Crank
X
Place jack
3
on firm ground.
X Position jack
3
under take-up bracket
2
so that it is always vertical as seen from
the side, even if the vehicle is parked on an
incline.
X Turn crank
4
clockwise until jack
3
is
fully seated in take-up bracket
2
and the
jack base evenly meets the ground.
X
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the ground.
Practical hints