Mercedes-Benz 2009 C 230, Руководство оператора

Страница: 374 / 404

Fuses
372
Fuses
Introduction
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and
systems secured by that fuse will stop
operating.
G
Warning!
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than
approved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center.
A blown fuse must be replaced by an
appropriate spare fuse (recognizable by its
color or the fuse rating given on the fuse) of
the amperage recommended in the fuse
chart. Any Mercedes-Benz Center will be glad
to advise you on this subject.
i In case of a blown fuse contact Roadside
Assistance or an authorized Mercedes-
Benz Center.
If a newly inserted fuse blows again, have the
cause determined and rectified by an
authorized Mercedes-Benz Center.
A fuse chart is located in the trunk with the
vehicle tool kit (
Y
page 302). The fuse chart
explains the fuse allocation and fuse
amperages.
Before replacing fuses
X
Engage the parking brake.
X
Make sure the automatic transmission is in
park position
P (manual transmission to
Neutral).
X
Switch off all electrical consumers.
X
Turn off the engine.
X
Remove the SmartKey from the starter
switch.
X Vehicles with KEYLESS-GO: Open the
driver’s door (this puts the starter switch in
position
0, same as with the SmartKey
removed from the starter switch). The
driver’s door then can be closed again.
Fuse box in passenger compartment
! Do not use sharp objects such as a
screwdriver to open the fuse box cover in
the dashboard. You could damage the fuse
box cover or the dashboard.
1
Fuse box cover
2
Remove cover
3
Release cover
X
Open the driver’s door.
X
Opening: Using your hands, pull cover
1
in direction of arrow
3
and remove
2
.
X
Closing: Hook cover
1
into the opening at
the front.
X
Press cover
1
back on until it engages.
! The fuse box cover must be properly
positioned as described to prevent
Practical hints