Mercedes-Benz 2007 R 320 CDI, Руководство оператора

Страница: 500 / 570

499
Practical hints
Flat tire
1
Wheel wrench
왘
On wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with wheel
wrench
1
).
The jack take-up brackets are located
directly behind the front wheel housings
and in front of the rear wheel housings.
2
Take-up bracket
3
Jack
4
Crank
왘
Place jack
3
on firm ground.
왘
Position jack
3
under the take-up
bracket
2
so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an
incline.
왘
Turn crank
4
clockwise until jack
3
is fully seated in take-up bracket
2
and the jack base evenly meets the
ground.
왘
Continue to turn crank
4
until the
wheel is a maximum of 1.2 in (3 cm)
from the ground.
!
Do not position the jack on the body of the
vehicle, as this may cause damage to the
vehicle.
Warning!
G
The jack is intended only for lifting the
vehicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle.
앫
Never start the engine when the vehicle
is raised.
앫
Never lie down under the raised vehicle.