INSTALLATION
INSTRUCTIONS
4
Rev 3.0
Make sure electricity is turned off at the
main power box before commencing
work. Turn off the power by removing
fuse or turning off circuit breaker before
installing remote controller.
HOW
TO
INSTALL
REMOTE
CONTROLLER
1.
This remote controller set has 16 possible code
combinations for wireless control
communication. Code setting on remote control
transmitter and receiver
must
match
each
other
for
operation
.
Otherwise
the
remote
controller
will
not
work.
The code setting can
be adjusted through 4 switches found on both
the transmitter and the receiver.
Setting
the
code
on
transmitter
I.
Remove battery cover.
II.
Slide code switches to your choice of ON
or OFF position. Use a small screw
driver or ball point pen to slide each
switch firmly up or down.
III.
Install battery (included)
IV.
Install battery cover on transmitter
Setting
the
code
on
receiver
I.
Slide code switches on the receiver so
that they are on the same positions as
those set on the transmitter.
If you wish to control two or more ceiling fans
independently with different set of remote
controllers, set different codes for each remote
controller set.
Possible
DIP
Switch
Setting
(ON
setting
represented
by
1;
OFF
setting
represented
by
0)
0000
0100
1000
1100
0001
0101
1001
1101
0010
0110
1010
1110
0011
0111
1011
1111
2.
Make sure power supply is cut off before
removing fan canopy.
3.
Think about best orientation of remote receiver
inside fan canopy. Connect receiver’s input and
output wires in accordance to wiring diagram
provided.
Note:
Isolation
switch
must
be
installed.
