FAN INSTALLATION INSTRUCTIONS
5
REV 1.0
4.
Fasten blade assembly, through blade fibre pad, to motor
with provided screws and washers. Repeat procedure for
remaining blades.
All blades are weighted and grouped accordingly,
therefore care should be taken when installing more than
one fan not to mix blade sets.
The following procedures should eliminate any wobble.
Check for wobble after each step.
a)
Check that all blade brackets are tightened securely.
b)
Most wobble problems result from inconsistent blade
level. To check blade level, measure the distance
from each blade tip to the ceiling. If measurements
are inconsistent, adjustments of brackets will be
required.
c)
Wobble problem could also result from deviations in
distance from blade to blade. To check blade
separation, measure the distance from blade tip to
blade tip. Should measurements vary, loosen screws
connecting blades and brackets (one at a time) then
shift the blade to proper position and re-tighten
screws.
REVERSING SWITCH
Always ensure fan is set to ‘OFF’ and blades are stopped prior to changing direction of blades. Reverse switch on the
fan should ideally be set on ‘FORWARD’ or “S” position during summer seasons to move blades in an anticlockwise
direction & ‘REVERSE’ or “W” position during the cooler seasons to make the fan rotate in a clockwise direction.
Do not mount wall controller near heat producing equipment.
Wall/remote controller provided is designed to be connected with the ceiling fan supplied in this package only.
Other uses may cause personal injury or fire hazard.
Use of wall/remote controller other than those approved by MERCATOR will void warranty.
Make sure electricity is turned off at the main power box before commencing work. Turn off the power by
removing fuse or turning off circuit breaker before installing the wall/remote controller.
WALL CONTROLLER INSTALLATION INSTRUCTIONS:
1.
Disconnect the power and remove existing wall plate and switch (if any).
2.
Set the speed control knob on the wall controller in the off position.
3.
Tighten screws on the terminal blocks; make sure wire connections are wired correctly and secure.
4.
Secure the wall controller to the wall with two screws provided
