SAFE AND CORRECT USE OF THE MACHINE
The machine to meet the different working needs permits the pressing time adjustment.
The control panel is extremely easy and intuitive.
Once the machine is switched on (by turning the switch 5-fig.3) it appears on the screen
“program nr. ….” To change the program number (from 1 to 20) press ENTER and one of the two arrows
(Upper arrow to increase the number – lower arrow to decrease the number) . To confirm press again ENTER.
- Press time - Pressing time. By arrows increase or decrease the pressing time (seconds)-
Enter.
- Opening set - dividing disk height. With arrows increase or decrease (in mm. max 47) the
height of the dividing disk -Enter
- Roll-time – Rounding time. With arrows increase or decrease the rounding time
(seconds)-
Enter
- Cutter Mode - program just for cutting. Pressing appears Cutter Mode and then
Press time. With arrows set the pressing time – Enter. To exit press again Cutter Mode.
It is necessary that the scaled doughs before be inserted in the machine are rounded and let rest for approx.
10/15 minutes)
Put the dough on the rounding plate and spread it in a uniform manner without let it exit from the round
stamps. Put a little quantity of flour on the dough upper part, if necessary, so introduce the plate
paying attention that the centering pin goes into the plate hole correctly.
Attention: if the rounding plate is not inserted correctly
the machine could suffer severe damage
KNIVES AUTOMATIC CLEANING FUNCTION – CLEAN (push-button 3 )
Operation to repeat every time before the machine switching off
With the push-button 3 (FIG.2) you can proceed with the cleaning as follows :
First of all place an empty plate inside the machine.
Press the button 3 (FIG.2) (on the display it will appears the writing WARNING – CLEAN CYCLE). Then press at
the same time the push-buttons 1 (FIG.2) until the push-button 3 starts to flash (FIG.2)
Now switch off the machine by means of the main switch 5 (FIG.3)
During the re-start repeat the reset operation ( turn the main switch 5 ( FIG.3), wait that the CLEAN 3 (FIG.2)
push button starts to flash and then press at the same time the buttons 1 (FIG.2) until the button 3 stops to flash.
(FIG.2)
At this time remove the plate with crumbs and impurities.
