6 GB
Disconnect the mains plug from the mains socket
and place it inside the compartment of the pump.
Deflating the air bed
Open the cover
4
on the pump
2
and take out
the mains lead and mains plug
5
(see Fig. C).
Insert the mains plug into the mains socket, and
turn the switch
6
to “deflate” (see Fig. F). The
air bed
1
should be fully deflated after approx.
4 minutes.
Turn the switch to “OFF” (see Fig. E).
Disconnect the mains plug from the mains socket
and place it inside the compartment.
Note:
When the air bed
1
is not completely
deflated, turn the switch
6
to the deflating mark
(see Fig. F). Begin rolling the air bed from the foot
of the air bed towards the head of the airbed where
the pump
2
is located. Repeat this step until the
airbed is fully deflated. Turn back the switch to “OFF”
position.
Maintenance
Mending the air bed
Note:
Minor damage may be repaired using the
supplied repair patch. Have any major damage
carried out at a specialist repair shop.
First let the air out of the product (see “Deflating
the air bed“).
Clean the damaged area with alcohol.
Abrade the area around the site of the damage
with fine sandpaper.
Cut a piece out of the plastic film of the repair
patch
7
.
Note:
Make sure that the repair patch largely
overlaps the edges of the leak.
Peel off the protective film from the back of the
repair patch.
Round the corners off and place the repair
patch over the leak or hole.
Place the repair patch onto the damaged part.
Press the repair patch firmly down onto the
leak. You may have to place a heavy object
onto the relevant area.
Wait for 24 hours before you pump up the
product again.
Cleaning and care
Do not under any circumstances use corrosive
or abrasive cleaning agents. These may dam-
age the surface of the product.
Clean the flocked surface of the product using
a brush.
Clean the plastic surfaces with water and / or a
little mild soap solution.
Ensure that the inside and outside of the product
are completely dry if you intend to store it in-
doors for a long period. Failure to observe this
advice could result in the build-up of mildew
and mould.
Fold up the product with the flocked surface on
the inside.
Store the product in dark, dry place – out of
reach of children.
The ideal storage temperature is between
10 and 20 °C.
Do not allow sharp objects to come into con-
tact with the product while it is in storage.
Never powder the product with talcum.
Make sure that the optional air valve
3
is shut
and turn the switch
6
to the “OFF”, if you
want to store the product for a long period.
Disposal
The packaging is wholly composed of
environmentally friendly materials that
can be disposed of at a local recycling
centre.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
73551_mer_Luftbett_Content_LB_SE_HU_SI_CZ_SK.indd 6
23.05.12 10:36
