10 GB/IE
CAUTION! RISK OF POISONING AND
RISK OF DAMAGE TO PROPERTY!
Do
not light a fire in the vicinity of this product and
keep it away from heat sources.
J
Please make sure that this product is placed on
a level surface and not on any sharp or
pointed objects. Otherwise damage to the
product can result.
J
Do not wash the product in the washing
machine.
CAUTION!
Ensure that the load placed on
the product does not exceed 160 kg.
Otherwise personal injury and / or damage to
the product may result.
J
Always use a suitable pump adapter with the
air valve. Failure to observe this advice may
result in damage to the air valve.
Q
Operation
Q
Pumping up the product
Note:
Before using the product for the first time,
check it carefully for holes, porous places and
seams that are not airtight.
Recommendation:
Pump the product up and
leave it alone for one day. Let a new product air
outside in fresh air for a couple of days.
CAUTION!
Inflatable plastic products react
sensitively to the cold and hot. That is why you should
never use the product when the ambient
temperature falls to below 15 °C and rises above
40 °C. Otherwise damage to the product may
result.
Note:
Basically, only an adult should be responsible
for pumping the airbed up. Make sure that you do not
pump too much air into the product. On no account
should you use a compressor. Stop the process
when resistance increases during pumping and the
seams start to stretch. Otherwise the material might
tear. Only use manual pumps and / or pumps
specifically designed for use with inflatable plastic
products.
j
Roll the product out first and then check for
holes, tears, and other damage (see. Fig. A).
j
Note:
You will need a pump with conical
adapter with a diameter of approx. 17.5 mm for
the screw valve to inflate the product (see. Fig.
B).
j
Turn the cover
2
of the stopper
1
anti-
clockwise off the air valve in order to open it
(see Fig. B I).
j
Pump up the product.
IMPORTANT!
Keep in mind that air
temperature and weather conditions can affect
the air pressure inside inflatable products. In
cold weather the product behaves as if it has
less air pressure in it because the air inside
contracts. Under these conditions you may
have to add air. In hot weather the air inside
expands. Under these conditions you may
have to remove air in order to avoid overfilling.
j
Hold a ruler line at least 10 cm long up to the
measuring strip
4
. The rated pressure is
reached as soon as the measuring strip
4
is
10 cm long (see Fig. D). The ruler is not
included with the product.
j
Stop the process as soon as the airbed is fully
inflated. If necessary let a little air escape.
j
Turn the cover
2
of the stopper
1
clockwise
onto the air valve to close it.
Q
Deflating the air mattress
j
Turn the stopper
1
anti-clockwise to open the
air valve (see Fig. B II).
j
Let all the air out of the product.
j
Slowly fold up the product (see Fig. A).
Note:
Ensure that the product is completely
dry before you fold it up.
Q
Maintenance
Q
Mending the airbed
Note:
Minor damage may be repaired using the
supplied repair patch. Have any major damage
carried out at a specialist repair shop.
292036_manual_CB8.indd 10
10/17/2017 9:46:46 AM
