
EN
29
11. Status light
12. Light sensor
13. Fault status light
14. Obstacle sensor
15. Handle
FIG. 1
ASSEMBLY
SIDE BRUSH
Fit the side brush beneath the corner brush.
BATTERY COMPARTMENT
Open the battery compartment and replace
the battery with a new one of the same type.
Press in the lock tabs to connect the battery.
Align the battery cover tabs to the square holes
and tighten the screws.
BRUSH WHEEL
Turn the robotic vacuum cleaner upside down
on a flat surface. Press on the middle brush
holder and take out the brush wheel together
with the roller bearing. Clean the brush wheel
and replace the bearing and brush wheel.
USE
• The sensors on the robotic vacuum
cleaner stop it from colliding with
obstacles and ensure that it covers all of
the floor. The step sensor prevents the
robotic vacuum cleaner from falling down
the stairs, and the light sensor allows it to
work in the dark.
• The side brushes, in combination with the
roller brush at the front, ensure effective
cleaning of wooden and tiled floors and
short-pile carpets.
CAPACITY
The dust container has a capacity of 0.3 litres,
which means the robotic vacuum cleaner seldom
needs to stop because it is full. The vacuum
cleaner can work up to 90 minutes per charge.
RUN MODE
Press the button to select run mode.
HOW TO USE
1. Fit the side brushes on the robotic vacuum
cleaner.
2. Place the vacuum cleaner in the middle of
the area to be cleaned.
3. Press the button to start the vacuum cleaner.
4. Press the button for the required mode.
5. Press any button to stop the vacuum
cleaner when it is running.
NOTE:
• If the vacuum cleaner stops and the red
status light starts flashing, check
whether the brush wheel is blocked. If
so, take out the brush wheel and clear
the blockage. Put the vacuum cleaner
back on the floor and start it.
• Charge the battery if the vacuum cleaner
stops and the green status light starts
flashing. The green status light flashes
during the charging and stops flashing
when the battery is fully charged.
• If the vacuum cleaner switches off, hold it
over a waste paper basket and press the
release button to open the lid over the
dust container to empty the dust container.
Switch off the vacuum cleaner.
• If the vacuum cleaner stops and the red
and green status lights start flashing at
the same time, press the button on the
side for five seconds to switch off and
then press again to start. Contact the
Содержание 007876
Страница 3: ...1 1 2 7 6 5 4 3 11 10 9 8 12 13 14 15 3 3...