85-03-00955
P a g e
|
60
7. Log #3 sits as shown in the image, below. The right rear corner of Log #3 touches the curved right corner of the
panoramic panel and the front left tip sits directly on top of the burner floor plate (Burner Airbox) approximately 1-
3/4” in front of the front edge of the burner.
8. Place Log #4 in front of the burner as shown, above. Log #4 may sit on top of Base Media as you desire and its left
to right location is not critical. However, avoid placing Log #4 on top of burner ports.
9. You may place Base Media randomly on top of the remaining burner surface. But do not pack media tightly. Leave
large gaps between media pieces. You may place multiple layer of media on top of the burner, however, be aware
that the flame appearance, flame height and flame color will vary depending media distribution. Definitely avoid
blocking off air slots in front and rear of burner. You can sparsely distribute Base Media over air slots but majority
of air slots must remain open to allow combustion air flow to the burner flames.
10. You may sprinkle inswool over Base Media and Burner Top loosely to gain glow effect and to hide burner surface,
if desired.
11. Below is an example of how the Driftwood Presentation appears when complete.
#3
#4
