57
HEARTH PAD SURFACE MUST BE
FLUSH WITH FIREPLACE BOTTOM
IF INSTALLING THE
WELLINGTON!!
HEARTH PAD
SURFACE
Information specific to the installation of Millennia Flat Grills, Victoria Filigrees and Tuscany Filigrees
The Millennia Flat Grills, Victoria Filigree and Tuscany
Filigree are designed to be “inside-fit” trim kits. All of the-
se trim kits fit within the inner perimeter of the Fireplace’s
Faceplate and remain flush within the Faceplate’s front
surface, see Figure below. This fitting method allows
flexibility in covering the black visible surface of the
Faceplate with non-combustible materials such as Tile,
Marble, Slate, Stone and Brick; as long as enough room
is allowed for the removal of these Mendota Designer
Fronts and the glass door for servicing,
WARNING: COMBUSTIBLE MATERIALS
MUST NOT COVER THE FRONT SURFACE
OF THE FIREPLACE’S FACEPLATE.
Figure 10
Information specific to the installation of the WELLINGTON FIRESCREEN FRONT:
The Wellington Fire screen Front is designed to be
“inside-fit” trim. The top and sides of these trim kits
fit within the inner perimeter of the Fireplace’s Face-
plate. The bottom member of this trim, however,
overlaps the bottom 2” black boarder of the fireplace
front faceplate. Therefore, DO NOT COVER THE
BOTTOM 2” BOARDER OF THE FIREPLACE
FACEPLATE WHEN INSTALLING THE
WELLINGTON FIRESCREEN TRIM. The sides and
top edges of the black visible surface of the Face-
plate may be covered with non-combustible materials
such as Tile, Marble, Slate, Stone and Brick; as long
as enough room is allowed for the re-
moval of this Mendota Designer Fronts
and the glass door for servicing,
Hearth Protection Pad Installation Infor-
mation when planning to install the Welling-
ton Front
If planning to install the Wellington Front, the hearth protection pad in-
stalled in front of the DXV-35 Fireplace must be designed, built and in-
stalled so that the hearth protection pad’s top surface is flush with the
bottom-most surface of the DXV35 Fireplace. See FIGURE 21.
Figure 12
DO NOT COVER THIS AREA OF THE FACEPLATE WHEN
INSTALLING THE WELLINGTON FIRESCREEN FRONT
O
N
LY
THE CROSS HATCHED AREA M
A
Y
BE CO
VERED
WITH NON
-COM
B
U
S
TIBLE
M
A
TERIAL
S WHEN INSTALLING
T
H
E
WELLI
N
G
TO
N FIRESCREEN F
R
O
N
T.
Figure 11
