18 of 28
Note: If the chimney is externally fi�ed or the stove has been installed
on a larger diameter clay chimney liner then on cold days it maybe
necessary to warm the flue using firelighters prior to ligh�ng with wood.
1. Place two small dry split logs (¼ split) on the fire bed. Kindling stacked as
in the picture allows combus�on air to flow freely and will aid igni�on. On top
of the kindling two or more non toxic firelighters.
2.
Fully open the secondary air control above the stove door on right hand
side. Fully open primary air control at base le� of stove. The Christon 400
air controls are now fully open.
3) Light the firelighters and push door to closed posi�on, latch in 1st
posi�on so the door is open 2 mm. (see picture) This provides addi�onal
combus�on air for start up and reduces condensa�on on the door glass.
NEVER leave the stove una�ended when the door is ajar in latch posi�on 1.
4. Once the flames from the logs are fully established , this can take up to
10 min's . The door can now be fully closed (posi�on 2). Once fire is burning
brightly again close the primary air control.
This will close off the primary air to the stove. If the stove begins to falter
a�er the primary is closed, open primary control again and leave un�l fire
has established, then close.
6. The fire should now be fully established and burning brightly. At this
stage close secondary air control by 50%, this is the opera�onal se�ng.
For the stove to burn cleanly and efficiently plenty of secondary air is
needed, do not be tempted to shut the fire down too early as this may
cause smoke. At nominal heat output, expect to refuel your stove once an
hour. Check load weights for your model on the table on page 6.
Use the glove when opera�ng air controls and door.
HOW TO LIGHT YOUR WOODBURNING STOVE
The stove will get very hot during use and due care must therefore be exercised.
Please use the glove when opera�ng air controls , door and ashpan.
Never let children “help” with the stove in any way, even when the stove is cold.
RE-FUELLING WHEN BURNING WOOD
To re-fuel your stove in the cleanest way only refuel your stove when flames have died down and you have glowing embers.
Before refuelling, open secondary air control fully, open primary air control fully. Open door, add two pieces of split wood
measuring approximately 30cm with a combined weight of 1.2kg. Close the door and leave the primary and secondary
air controls open un�l fire is re-established with flames. Close primary air control and slide secondary air control to the
opera�onal posi�on (50% open).
Experience will determine the se�ngs that produce best results, this may vary with the type and quality of the wood being
used in the stove.
Door handle Posi�on 1
