2.5” Bulldog User Guide
April 10, 2006
page 5 of 14
3.1.4 MOUNTING
The AT2515 may be mounted in any orientation. A total of eight bottom and eight side
mounting holes are available for installation. The mounting holes require M3 screws with a
maximum depth of 5 mm.
The diagram given below is valid for all capacities of the AT2515 drive. The outline
dimensions are 2.75” (69.85 mm) wide, 3.94” (100.2mm) long, and 0.315” (8.00mm) tall.
Please refer to the following drawing for dimensions and mounting hole locations
Figure 2 - Mechanical Dimensions
3.1.5 COMPUTER SETUP
To be recognized by the computer, the drive translation information must typically be entered
into the System Setup or CMOS Setup utility. For non-PC compatible computers, this may not
apply. The AT2515 supports automatic detection and configuration if offered by the BIOS. If
the drive configuration must be manually entered, select drive type USER and use the table
below to determine proper setup parameters. Automatic CHS translation and LBA mode is
supported. Note that a MB is equal to 1024*1024 bytes.
