Amplifier Controls Continued
Installation
+12V:
This is the power terminal for the amplifier. This should be connected directly to the +12V terminal of the battery. This power cable
may cause unwanted noise in your system if it is ran parallel to RCA cables. It is always a best practice to avoid running this cable parallel
to any RCA wires.
REM - Remote Terminal:
Connect the remote turn on wire. This wire provides a signal to the amplifier to turn the power ON when the audio
system is started.
GND: Ground Terminal:
A proper ground is required for your amplifier to operate at peak performance. Use a matching gauge ground and
+12V wire. Use a short ground wire and connect it directly to the vehicle’s chassis in a location that is free of paint, dirt and other items
which may degrade the quality of the connection.
FUSE:
This unit uses a 20A fuse
Memphis recommends installations be performed by trained Memphis audio authorized dealers. Installing this system yourself can result in
damage to your vehicle and the system itself. Installation done by anyone other than an authorized Memphis Audio dealer may void the
warranty.
1. Disconnect the battery
2. Locate a mounting location for your bass tube.
3. Install the +12V power cable from the battery. Always install a circuit breaker or fuse within 18” of the battery. This lowers the risk of
damage to your vehicle or the unit itself.
4. Locate a proper grounding location for the GND wire of the unit. Remove any paint and clean the surface where the ground wire will be
connected. Connect your ground wire to the vehicle chassis and to the GND terminal of your SRX18PT.
SRX18SPT
BASS TUBE
SR
S T R E E T R E F E R E N C E
Memphis Audio, Established 1965, Memphis TN, USA | www.memphiscaraudio.com