Space Approx.
2" apart.
WARNING:
Mounting clamps
backwards will cause
damage to your tank.
Throttle side,
front of bike
INCORRECT
CORRECT
Adjust Fork Clamp as needed
and check for clearance.
(See
above "Read and Follow
Directions Warning.")
Bushing Assembly
1. Place lower slot into lower bushing.
2. Rotate top slot into place.
3. Secure locking Mechanism.
4. Loosen Allen Bolt to adjust angle,
then re-tighten Allen Bolt.
1
2 3
4
CORRECT
Fully engaged
Locking mechanism
NOT CORRECT
Latch
assembly
#memphisshades
5. Fork Clamp Bushings are pre-adjusted to rear of slot.
Adjust as needed and check for clearance. (Fig. 3 & 4)
(See Warning)
6. Slip the mounting plates and fairing onto the fork clamps,
(Fig. 5) while guiding the bezel over the headlight (Fig. 2)
and under the brow. Secure the left and right side locking
mechanism
7. Adjust the height, angle and alignment of the fairing and
tighten
ALL
bolts.
Note: This is a detachable fairing, ALWAYS make sure
the Locking Mechanism is Fully Engaged after installing
the windshield! (Fig 6)
2. Mounting Instructions, continued
Fig. 1
Headlight Bezel
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
brow spacer
brow
retaining bolt
