Part No. 2321-0172
2. Mounting Instructions, continued
Fig. 4
5. Install the Throttle side bracket
q
by placing the support
washer
u
into the upper hole, “the large part faces out, the
small part faces in” followed by the bracket and then
loosely install the 8mm x 25mm button head cap screw
w
and 8mm Flat washer
v
. (Fig 2)
6. Locate and remove the two unused bolts in the lower
triple tree, one on each side of the headlight and discard.
Install the lower screw by inserting one of the new 8mm x
30mm button head screws
t
in this order, through the
bracket
q
, through the spacer
s
and tighten the lower and
upper bolt.
7. Repeat step 6 for the Clutch side bracket
p
. (Fig 2)
8. Install the fairing by placing the lower slots into the lower
mounting bushings. Slip the upper slots into the upper
mounting bushings and gently but firmly seat the slots into
place. Lock the locking mechanism into place. (Fig 3 and 4)
9. Adjust the height, angle and alignment of the fairing and
tighten
ALL
bolts.
Note: This is a detachable fairing, ALWAYS make sure
the Locking Mechanism is Fully Engaged after install-
ing the fairing! (Fig 4)
Fig. 1
Fig. 2
Fig. 3
Yamaha Roadliner / Stratoliner 2006- 2010
MS Batwing Fairing
Mounting kit, Black
Step 2
Step 1
Step 4
Step 3
1. Place lower slot into lower bushing.
2. Rotate top slot into place.
3. Secure locking Mechanism.
4. Loosen Allen Bolt to adjust angle,
then re-tighten Allen Bolt.
CORRECT
Fully engaged
Locking mechanism
NOT CORRECT
R322C/T
LATCH
ASSEMBLY
