Part No. 2321-0252
2. Mounting Instructions, continued
Fig. 3
4. Using the 6mm Allen wrench provided, remove the upper
triple tree pinch bolt.
5. Using a 10mm and 13mm socket, loosely install the
lower bracket using the new bolts and washers pro-
vided.
Next, slip the spacer behind the upper bracket mounting
hole and insert the new socket head cap screw with new
washer through the bracket, through the spacer and loosely
tighten all three bolts. (Fig 2) repeat steps 3 - 5 on the
Clutch side.
Note: You will tighten these bolts after the fair-
ing is installed on to the bushings.
6. Install the fairing by placing the lower slots into the lower
mounting bushings. Slip the upper slots into the upper
mounting bushings and gently but firmly seat the slots into
place. Lock the locking mechanism into place. (Fig 3)
7. Tighten all mounting bolts. Adjust the height, angle and
alignment of the fairing and tighten
ALL
bolts.
Note: This is a detachable fairing, ALWAYS make sure
the Locking Mechanism is Fully Engaged after install-
ing the fairing!
Fig. 1
1. Place lower slot into lower bushing.
2. Rotate top slot into place.
3. Secure locking Mechanism.
4. Loosen Allen Bolt to adjust angle,
then re-tighten Allen Bolt.
1
2 3
4
Fig. 2
CORRECT
Fully engaged
Locking mechanism
NOT CORRECT
R322C/T
LATCH
ASSEMBLY
Mounting Kit
Bullet FX Fairing
Phantom
