3
PREPARATION FOR USE (CONTINUED)
SPEAKER CONNECTION
1. Place the speakers in convenient locations on either side of the unit. Usually a
distance of
fi
ve to eight feet between speakers provides the best stereo effect, but
this may vary depending on the size and acoustics of the room.
2. Locate the Speaker Terminals on the rear of the unit and connect the solid red wires
to the red (+) terminals and connect the black wires to the black (–) terminals.
3. To connect the speakers, press the terminal down, insert the speaker wire and
press the terminal back to the lock position.
4. Pull lightly on the connection to make sure it is secure.
CAUTION:
Only connect the speakers which are supplied with the unit. The use of any
other or additional speakers may cause damage to the unit. Never operate the unit
without the speakers connected.
BATTERY OPERATION
The battery compartment is located on the rear of the remote control.
• Remove the battery compartment door by pressing down and sliding the door in
the direction of the arrow.
• Insert two (2) AAA size batteries into the battery compartment as shown to the
right. Be sure to observe the polarity markings which are engraved inside the
battery compartment. If the batteries are inserted incorrectly, the remote control will
not operate.
• Replace the battery compartment door.
CONNECTING AN EXTERNAL UNIT TO THE AUX
IN JACKS
You can connect an external unit to the MX4111, such as a
cassette player, etc. Simply connect a audio/video cable (not
included) from the AUX IN jacks of this MX4111 to the external
unit’s AUX OUT jacks. This will allow you to broadcast the
external unit’s sound through this unit. Press the FUNCTION
button to select “AUX” to use the external unit.
NOTE:
Please refer to the external unit’s owner’s manual for
more details.
+
+
—
—
REMOTE SENSOR
To operate the unit with the remote control, point the remote at the remote sensor on the front of the main
unit and press the appropriate button. The remote control has an effective operating range of approximately
15 feet and an angle of no more than 30°.
NOTE:
Bright sunlight may interfere with the operation of the remote control.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries speci
fi
ed (alkaline are recommended).
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer’s directions.)
From
Aux
In
To
Aux Out
EXTERNAL UNIT
MX4111
MX4111.O/M.QXD 7/11/02 4:06 PM Page 3