Mellerware Rider Pro, Руководство пользователя

Страница: 8 / 52

F Battery
G Button to open dust tank
H Button to release the dust tank
I Battery indicator
J Speed control
K Speed indicator
L Wall mount screws
M Wall mount bracket
N Power supply
ACCESSORIES
a) Motorized brush “Power Brush”
b) Crevice tool
c)
2in1 upholstery nozzle
d) Pet brush (*) (***)
e) Sofa/bed motorized brush (*)
f)
Motorized brush “Turbo Brush” (**)
g) Water tank (**)
(*) Only available in the model RIDER PRO ANI-
MAL and RIDER PRO FULL SET.
(***) Pet brush only fits with the motor body, not
with the extension tube.
(**) Only available in the model RIDER PRO
CLEAN and RIDER PRO FULL SET.
-If the model of your appliance does not have
the accessories described above, they can
also be bought separately from the Technical
Assistance Service.
INSTALLATION
-Be sure to remove all packaging material from
inside the appliance.
ASSEMBLING THE WALL BRACKET:
-The appliance has a wall bracket (M) which
-Fix the wall bracket as you think appropriate,
using plugs, screws, and adhesive…
-
should be able to support twice the weight of
the appliance.
-Fit the appliance into the wall support.
CHARGING THE BATTERY
-Caution: A new battery is not fully charged and
must therefore be charged before the appli-
-Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
-Plug the charger (N) into the mains.
-A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
-Approximately 3 to 4 hours are needed for a
complete charge of the battery. Never attempt
to over-charge the battery (although it is rec-
be of 5 hours in duration).
-Connect the charger to the jack using the
socket on the appliance. The socket is located
at the lower/back part of the appliance.
-The pilot light will come on to indicate that the
charger is charging the battery.
-
remove the battery from the charger.
-When the battery is charged disconnect the
charger from the mains supply.
-NB: Do not use the appliance while it is con-
nected to the charger.
INSTRUCTIONS FOR USE
BEFORE USE:
-
important to make a full charge of batteries.
VACUUMING FUNCTION:
-Fit the extension tube (E) to the air intake of the
vacuum cleaner and the motorized brush (a) at
the end of the extension tube.
-To disconnect the extension tube from the
vacuum cleaner and the motorized brush,
press the accessories release button and pull
outwards (Fig.2).
USE:
-Turn the appliance on, by using the on/off
button (C).
-The battery indicator (I) and speed indicator (K)
will turn on.
-Select the desired speed using the button (J).
FITTING AN ACCESSORY TO THE HAND
VACUUM OR TO THE EXTENSION TUBE:
-The hand vacuum is designed in such a way
that it allows the following accessories to be
your requirements).
RIDER PRO model:
- Motorized brush “Power Brush”
- 2in1 upholstery nozzle
- Crevice tool