3.2.6. To ensure that the front and rear grilles are se-
screw (O). This should be introduced through the hole
so that the grille’s cannot be separated without the use
of a tool.
3.3. Use and care
:
3.3.1. Unroll the cable completely before plugging it in.
3.3.2. Connect the appliance to the mains electrical
supply.
desired direction.
3.3.4. Select the desired speed.
3.3.5. Height Adjustment:
The height of the appliance can be adjusted by loosen-
ing the control, setting the appliance to the desired
height and tightening the control again.
3.3.6. Oscillating function:
The oscillating function makes it possible to direct
alternates over a range of 75º.
To activate this function press the oscillating function
control (T).
3.4. Carry handle:
This appliance has a handle on the back to make it
easy and convenient to transport.
3.5. Safety trip switch:
The appliance has a safety trip switch that protects the
appliance from overheating.
3.6.1. Allow fan blade to come to a complete stop.
3.6.2. Unplug the appliance from the mains power
supply.
3.6.3. Clean the appliance as described in the cleaning
section.
4. Cleaning
4.1. Disconnect the appliance from the mains power
supply and allow it to cool completely before undertak-
ing any cleaning task.
4.2. Remove the front grill in order to clean the propel-
ler. When removing the front grill to clean the propeller,
make sure that the fan is unplugged before
removing the guard.
4.3. Clean the outer parts of the appliance with a damp
cloth with a few drops of washing-up liquid and then
dry. CAUTION! Do not immerse electrical parts of the
appliance in any liquid.
4.4. Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products, for
cleaning the appliance.
4.5. Never submerge the appliance in water or any
other liquid or place it under running water.
5. Anomalies and repair
5.1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
5.2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
