Mellanox Technologies SX1012, Руководство пользователя

Страница: 48 / 107

Interfaces
Rev 1.4 51 Mellanox Technologies
3.2.6 Reset Button
The reset button is located on the front side panel under the status LEDs. This reset button
requires a tool to be pressed.
 To reset the system and the CPU of its management board, perform the following:
Push the Resetr button and keep it pressed for up to 14 seconds.
 To reset the system, the CPU of its management board and the “admin” password, perform
the following:
Push the Reset button and keep it pressed for at least 15 seconds. You will then be able to enter
without a password and set a new password for the user
“admin” .
In the externally managed systems the reset button resets the device.
3.3 LEDs
3.3.1 LED Notifications
The system’s LEDs are an important tool for hardware event notification and troubleshooting.
Mellanox systems have two types of LEDs:
• Status LEDs
• Port LEDs
The Status LEDs are located to the left side of the front panel and on the power side at the far
right. The port LEDs are located on top of the data ports- see Section 3.3.
DO NOT use a sharp pointed object such as a needle or a push pin for pressing the
Reset button. Use a flat object to push the reset button.