Installation
Rev 1.2
Mellanox Technologies
24
Figure 17: Sliding the Switch into the Rack
2.4.2.1 Removing the System from the Rack
To remove a unit from the rack:
Step 1.
Turn off the system and disconnect it from peripherals and from the electrical outlet.
Step 2.
Unscrew the two M6 screws securing the front of the inner rails’ ears to the outer rails and to
the rack.
Step 3.
Pull the unit out until braking is felt. For safety purposes, the locking mechanism will not allow
a complete removal of the unit at this stage.
Step 4.
Press on the locking spring (appears in red in Figure 19) on both sides simultaneously, and con-
tinue pulling the unit towards you until it is fully removed.
Figure 18: Pulling the Unit Outwards
Содержание SB7700
