38
Rev 1.2
Mellanox Technologies
3. Gently place the label as shown in Figure 15. Make sure to align the center hole of the label with the drilled hole
in the board.
4. After placing the label, complete the process by (gently) sweeping your thumb on the label to assure the label is
well-attached onto the board. See Figure 16.
See also Figure 21, “Print Side View After Short Bracket Assembly With Kapton Label,” on page 40.
Now your card is ready for a short bracket assembly.
C.3 Assembling Short Bracket
The short bracket can now be assembled onto the HCA card.
Figure 15: Place Label on Print Side With Label’s and Card’s Holes Aligned
Figure 16: Ensure That Label is Well-attached